Team:UNIPV-Pavia/Notebook/Week3Oct

From 2009.igem.org

Revision as of 23:40, 21 October 2009 by 110hs (Talk | contribs)

EthanolPVanimation.gif

December 2008
M T W T F S S
1 2 3 4 5 6 7
8 9 10 11 12 13 14
15 16 17 18 19 20 21
22 23 24 25 26 27 28
29 30 31
March 2009
M T W T F S S
1
2 3 4 5 6 7 8
9 10 11 12 13 14 15
16 17 18 19 20 21 22
23 24 25 26 27 28 29
30 31
April 2009
M T W T F S S
1 2 3 4 5
6 7 8 9 10 11 12
13 14 15 16 17 18 19
20 21 22 23 24 25 26
27 28 29 30
May 2009
M T W T F S S
1 2 3
4 5 6 7 8 9 10
11 12 13 14 15 16 17
18 19 20 21 22 23 24
25 26 27 28 29 30 31
June 2009
M T W T F S S
1 2 3 4 5 6 7
8 9 10 11 12 13 14
15 16 17 18 19 20 21
22 23 24 25 26 27 28
29 30
July 2009
M T W T F S S
1 2 3 4 5
6 7 8 9 10 11 12
13 14 15 16 17 18 19
20 21 22 23 24 25 26
27 28 29 30 31
August 2009
M T W T F S S
1 2
3 4 5 6 7 8 9
10 11 12 13 14 15 16
17 18 19 20 21 22 23
24 25 26 27 28 29 30
31
September 2009
M T W T F S S
1 2 3 4 5 6
7 8 9 10 11 12 13
14 15 16 17 18 19 20
21 22 23 24 25 26 27
28 29 30
October 2009
M T W T F S S
1 2 3 4
5 6 7 8 9 10 11
12 13 14 15 16 17 18
19 20 21 22 23 24 25
26 27 28 29 30 31
November 2009
M T W T F S S
1
2 3 4 5 6 7 8
9 10 11 12 13 14 15
16 17 18 19 20 21 22
23 24 25 26 27 28 29
30

Week from October 12th, to October 18th, 2009

Previous Week Next Week

October, 12th

  • We repeated the digestion for F2620TOP10(S-P) and B5new2-3(X-P-ClaI).
  • Gel run/cut for the two plasmids: bands were good.
  • Gel extraction for:
    • F2620TOP10(S-P)
    • B5new2-3(X-P-ClaI)
    • B3(X-P)
    • B4(X-P)
    • A19-1(S-P)
  • Unfortunately we had a very low DNA yield for almost all of them: A19-1(S-P) and F2620(S-P) could not be used :'(
  • We decided not to repeat A19-1 extraction (and then the A21 re-cloning) and to assay our A21 construct for ethanol production.
  • F2620 DNA was over, so we inoculated 8 ul of F2620MIT1 glycerol stock in 7 ml of LB + Amp. We incubated this inoculum overnight (37°C, 220 rpm).
  • We inoculated 12 of our assemblies in 3 ml of LB + Amp in order to prepare the DNA to send to iGEM HQ:
    • A1
    • A2
    • A3
    • A4
    • A5
    • A6
    • A7
    • A8pg
    • A9pg
    • A11-3
    • A12-2
    • A15-3
  • We ordered a gas chromatography for a sample of the supernatants (taken the previous day).

Top

October, 13th

  • Miniprep for the 12 inocula to be sent.
  • Miniprep, cut S-P, gel run/cut/purification for F2620MIT1. This time we had a good yield;)
  • Ligations:
    • B14 = F2620(S-P) + B3(X-P) in pSB1A2
    • B15 = F2620(S-P) + B4(X-P) in pSB1A2
  • We incubated them at 16°C overnight.

Top

October, 14th

  • We transformed the two ligations (after 1:20 dilution) and incubated the plated bacteria overnight (37°C).
  • We inoculated all the remaining assemblies (12) in order to send purified DNA to iGEM HQ (3 ml of LB + Amp).
  • We inoculated 8 ul of B5new2-3, F2620TOP10 and B0015 glycerol stocks in 8 ml of LB + Amp + 2% glucose. We incubated them at 37°C, 220 rpm in the morning.
  • Team meeting

Top

October, 15th

  • We diluted 25 ul of A14S-3 in 3 ml of LB + Amp and in 3 ml of LB + Amp + 1mM IPTG. We incubated the two cultures at 37°C, 220 rpm for 6 hours. Then we measured OD600 and fluorescence, but unfortunately their GFP levels were the same.
  • Miniprep for the remaining BioBricks.
  • pH measurement for B5new2-3, F2620TOP10 and B0015 24 hour cultures. We diluted 1:100 these three cultures in LB + Amp + 10% glucose and aliquoted them in the microplate reader (anaerobic).
  • We inoculated 4 colonies of B14 plate and 3 colonies of B15 plate in 5 ml of LB + Amp and incubated them at 37°C, 220 rpm overnight. Tomorrow they will be screened!
  • We received gas chromatography results.

Top

October, 16th

  • Cloning
  • Fermentation experiment setup
  • Wiki updating


Top

October, 17th

  • Wiki updating

Top

October, 18th

  • Wiki updating

Top


Previous Week Next Week