• Dear Judges
• Project Results
• Medal Checklist

Project Results

Our Results can be roughly divided in two sections, the biobrick assembly from starting parts in order to create our (test)-devices and secondly the characterizations of a part.

First and foremost the following biobricks were succesfully assembled and sent to the registry:

Experimental results

Furthermore, the blue light promotor was extensively characterized. The strength of the promoter was compared to the standard iGEM promoter, , using the protocol from the iGEM measurement kit.

Comparison of the blue light promoter (blue) to a standard promoter strength (orange) in RPU. The blue light promoter shows ca. half the strength of the standard promoter, meaning it can be classified as a weak promoter

Next, the effect of blue light on this promoter was examined. As shown on the graph below, blue light irradiation has a significant effect on the strength of the promoter. However, aside from light, temperature also has an important effect on promotor strenght (possibly even bigger then light). For instance, when using low copy plasmids, temperature will influence the promoter/repressor ratio. Cells grown at 37°C will have a too large effect on the promoter, resulting in constitutive activity. At 16°C, there will be more repressor and more receptor, however the low temperature will put the receptor in its active state causing it to inhibit the repressor from doing its job. When grown at 25°C the ratio between repressor and receptor is better, without light irradiance the receptor/represssor are in there ground state resulting in a good repression of the promoter.

Effect of blue light irradiance on promoter strength. Cells grown under blue light irradiance (blue) show a stronger expression compared to cells grown in the dark (grey)

Experimental set-up

Liquid cultures were ented (and re-ented in the evening) and grown on two different temperatures: 37° and 25°C. Note: enting of the cultures needs to be done in a dark room (red light)and it might be best to use medium that was put at 4°C overnight. From each of these growth conditions some of the cultures were put in 16° and the other at 25°C. Each of these groups were then again divided in a group that was exposed to blue light and a group that was not exposed to light. We decided upon using FACS because then the fluorescence of single cells is measured. Since each time the fluorescence of 10,000 individual cells is measured, FACS allows more elaborate and accurate statistical analysis. Our samples were analyzed by flow cytometry with a Becton Dickinson FACSCalibur and CELLQuestTM acquisition and analysis software with gates set to forward and side scatters characteristic of the bacteria (Gate G2=R2). Measurements were done at following hours: 0h;0,5h;1,5h;3h;4,5h;6h;8h. The construct used for our test was a ligation of the blue light promotor in front of GFP using three different vectors (pSB3K3, pBR322 and pSB1A2). (An example of a sample name is: 37/16/NB/LigA, grown at 37°, put in 16°, not lit and in vector pSB1A2. ) It's important to know that the regulation of this promotor is very sensitive and that all factors need to be calculated into the experimental setup. For instance, since temperature has an equally high effect on the promotor as blue light has, cultures grown at 37°C will have a different GFP signal compared to cells grown at 25°C. To learn more about the mechanism, we refere to the following articles:

• Tschowri, N., S. Busse, and R. Hengge. 2009. The BLUF-EAL protein YcgF acts as a direct anti-repressor in a blue-light response of Escherichia coli. Genes Dev. 23:522–534.
• Gomelsky M., Klug G. BLUF: A novel FAD-binding domain involved in sensory transduction in microorganisms. Trends Biochem. Sci. 2002;27:497–500
• Nakasone Y., Ono T.A., Ishii A., Masuda S., Terazima M. Transient dimerization and conformational change of a BLUF protein: YcgF. J. Am. Chem. Soc. 2007;129:7028–7035