Team:Paris/Production modeling

Protocols Freezer NoteBook Bibliography Parts WetLab DryLab

Team Collaborations Contacts Acknowledgements Links

DryLab

Improving message quality

This part aimed at solving the first problem linked to the creation of messengers :

Obviously, it is crucial to send vesicles only when the concentration of proteins to encapsulate is at its maximum level in the periplasm. To optimize the quality of our message, we tried to make this peak of vesicles creation corresponding to maximum levels of protein concentration. We assumed that the number of vesicles produced is at its maximum when the concentration of TolRII has reached its peak.

In what follows, we consider two different designs for implementing the delay: using a transcriptional cascade and using feed-forward motifs. We found that the design based on transcriptional cascade is sufficient for obtaining the desired delay, whereas the design based on feed-forward motifs allows for more flexibility, at the cost of an increased complexity. These studies are described below.

Implementing the delay by a transcriptional cascade

We have decided to construct the following system. The addition of arabinose to the medium leads to the activation of the pBad promoters: two proteins are produced: the protein to encapsulate and LacI-LVA. The latter inhibits the expression of TetR and thus releases the inhibition of TolRII, responsible for vesicle formation.

To study this system, we simply used differential equations. We used the method described by U. Alon in his book An Introduction to Systems Biology, with notably Hill functions to describe the regulation of the promoters.

The network behavior can be described by a system of differential equations:

Differential System

As a first approximation, we assumed that :

• When the pBad promoter is induced, the concentration of arabinose in the medium is very high and constant during he whole study; as a consequence, we will consider that the creation rate of Protein P and LacI* is constant during the experiment:

• We considered that all the binding constants are identical and of an average of 40nM which correspond to approximately 40 monomers per cell; we can write that:

• We chose identical intrisinc promoter activities, β, all equal to 4000 proteins/cell cycle:

• All the time units were expressed in units of cell cycle (approximately half an hour). As a consequence we chose a dilution rate γ of 1 for protein without special tags. For the LacI protein with a degradation tag (LacI-LVA), the dilution rate is 3 times higher:

For simulation, we used the following initial quantities:

• 4000 units of TetR (steady state level at inactivation)
• no protein to be encapsulated
• no LacI
• no TolRII

We got the following dynamics using Matlab software, showing that this simple system is capable of generating the desired behavior.

Implementing the delay by feed-forward motifs

Using the delay system in our genetic regulatory network, we were able to find a way to get a maximum quantity of TolRII when the concentration of exported proteins is at its maximum.

The previous system seems sufficient to tune maximum TolRII production with maximal vesicles production. However, getting a good modularity in the emission of a message is compulsory to design a good communication system ; therefore, we examined another device to achieve the same goal but with a more flexible behavior.

The Feed Forward Motif

The feed forward motif was studied and described by U. Alon in his book "An Introduction to Synthetic Biology" where he describes the different form of existing feed forward ; they can be either coherent or incoherent.

In each case, there exist a different network organisation to create a feed-forward loop as shown on the picture

The X and Y inputs can be combined either using a logical AND or OR gate thus giving different dynamics properties in each case.

The coherent feed forward loop allow the creation of a delay either on activation or on desactivation depending on the logical function between the two input X and Y. When the output logical gate is an AND function, the delay appears on activation, while when the output gate is an OR function, the delay appears on desactivation. An example of caracterised feed-forward loop is the fliA system which was used by the 2008 Paris team in order to create a oscillator.

In an incoherent feed forward loop, the two inputs of the last gate function have two different logical levels; one molecule (molecule X for example) is an activator while the other molecule is a repressor of the promoter controlling the expression of the output. This way, when the input signal is on, the expression of molecule X starts activating both the promoters controlling the expression of Y and Z ; transcription starts and the amount of Y and Z molecules increases. Nevertheless, when the concentration of Y has reached its repression threshold, repression starts and the concentration of Z molecule decrease to its steady state.

Two elementary incoherent feed forward motifs can be combined in order to create two time delayed bursts as described by U.Alon in its description of the development of Bacillus Subtilis spore. Anyway, it seems quite difficult to find a molecule which would be both an activator and a repressor ; we decided to try and think about another combination of these two feed forwards so as to get the dynamics we wanted as shown on the following part.

Our design proposition

The two feed-forward loops used are incoherent and agenced in a way that each molecule is either an activator or a repressor (and not both). The following scheme gives the functionning of the system.

To study the dynamics of our model, we decided to use a classical approach using Michaelis-Menten equations to medel the activation and repression of the various promoters, including a cooperativity of order 2 for the repressor which often the case for 'classical' repressors such as LacI. We obtained the following system of equations :

It is possible to obtain a important scale of values according to the choice of an optimized β for the production of molecule Z3 whose steady concentration and production rates impact on the steady state concentrations of the protein exported as well as the TolRII expressed. The β is chosen initially equal to 40 and 400 molecules by cell cycle and we have plotted the different response for multiples of this initial value.

In each case, the initial conditions are the same :

• no proteins encapsulated
• no TolRII
• no Z1 molecules
• no Z2 molcecules
• no Z3 molecules
• a weak amount of Z4 molecules (around a hundred)

A flexibility of Behaviour

Regardless of the steady state concentrations of the molecules, the use of two incohenrent feed forward loops allow a more important flexibility in the design of our system. With a simple delay system, we just get one possible dynamic behavior while using a variable range of production rates, we can obtain two behaviors :

• First, when the β is weak (β = 40), the number of TolRII produced slowly increase before returning to zero without another input signal of any kind ; on the other hand, the protein exported inside the vesicles is created very quickly and remains at a high concentration compared to the TolRII protein ; we can therefore send vesicles containing an important amount of interesting proteins and, after a while, stop expressing dangerous proteins for the cell. All of this can be performed with and single input signal.

• When the β is stronger, the behavior is different and we notice a change of concavity of the TolRII curve when the amount of protein exported is at its maximum. During such a change of concavity, the derivative reaches its maximum - in other words, the amount of TolRII produced by time units is at its highest level. Considering the hypothesis according to which the number of vesicules by time units would be more important when the production of TolRII by time units is at its maximum, we get a peak in vesicule production in this case.

In any case, the number of TolRII proteins is less important than the amount of exported protein, thus protecting the cells from lysis.