"
In Vitro Assays
Introduction
After the cloning, expression and the purification of the Fok constructs we conducted several assays to analyse the activity of the enzyme. To establish the assay and as a reference for activity we used wildtype FokI. Binding of the modified nucleotides and enzymatic activity were tested with the Fok_i / Fok_a construct.
Cutting with FokI wildtype
First the ability of FokI wildtype to cut ssDNA hybridized with a short oligonucleotide had to be confirmed. M13 ssDNA was isolated which contains four FokI cutting sites. For two of them complementary oligonucleotides were ordered with a length of 40 bases (Link zur Oligoseite) as a oligo with this length should form a helix with the M13 DNA. The M13 ssDNA was hybridized with the oligonucleotides and then incubated with FokI for 30 minutes. We ran a 1% agarose gel and the first gels showed a strong degredation of the ssDNA with no distinct fragment visible on the gel. But after reducing the amount of FokI and the time of incubation a clear fragment pattern showed up.
 |
| Figure 1: Agarose gel of FokI cutting M13 ssDNA and dsDNA |
M: GeneRuler DNA Ladder Mix (Fermentas, 6 µl);
1: Untreated M13 ssDNA (300 ng);
2: Digest of M13 ssDNA with FokI and with the nucleotide Fok control 1;
3: Digest of M13 ssDNA with FokI and with the nucleotide Fok control 2;
4: Digest of M13 ssDNA with FokI and with the nucleotide Fok control 3;
5: Digest of M13 ssDNA with FokI and with the nucleotides Fok control 2
and 3;
6: Digest of M13 ssDNA with FokI and with the nucleotides Fok control 2
and 3, heat inactivation at 95°C 10 min;
7: Digest of M13 ssDNA with FokI and with the nucleotides Fok control 1
and 2;
8: Digest of M13 ssDNA without FokI and with the nucleotides Fok
control 1 and 2;
9: Digest of M13 ssDNA with FokI and with the nucleotides Fok control 1
and 3;
10: Digest of M13 ssDNA with FokI and with the nucleotides Fok control
2 and 3, kept on 37°C after the hybridization;
11: Digest of M13 dsDNA with FokI.
The M13 DNA has a size of 7259 bp. The digest of dsDNA with FokI wildtype would lead to the following fragment pattern: 900 bp, 3560 bp, 2780 bp, 200 bp. This pattern was visible at the gel in lane 11. Cutting with the nucleotides Fok control 2 and 3 should create two fragments with sizes of 6100 bp and 1100 bp. The gel picture shows two fragments at the right size in the lanes 5 and 6 and some uncut vector in lane 6. Incubation with Fok control 1 and 2 should cut out a 200 bp fragment which couldn't be seen on the gel in lane 7. Probably the DNA concentration was to low to detect this small insert. The digest with Fok control 1 and 3 in lane 9 didn't provide the fragments of 906 bp and 7100 bp. Maybe the Fok control 1 nucleotide didn't work right, as both digests with this nucleotide failed. The negative control in lane 8 didn't show any shorter fragments. The digest in lane 10 didn't work because we forgot the DNA.
Methods
Hybridize M13 ssDNA with Fok control oligos 2 and 3
| Volume | Reagent |
| 10 µl | M13 ssDNA (c = 127 ng/µl, 17.08.09, sample #5.2) |
| 5 µl | MgCl2 (5 mM) |
| 5 µl | Tris-HCl pH 8 (100 mM) |
| 2 µl | Fok control 2 (10 ng/µl; 1 µM) |
| 2 µl | Fok control 3 (10 ng/µl; 1 µM) |
| 30 µl |
The hybridization was also done with just Fok control 2 and
with no oligos at all.
Incubation with the thermocycler and the program ORIGAMI0 (heat to
95°C and cool down slowly to 37°C over 1 hour).
10 µl of the hybridized DNA were used for a cutting
experiment
with 1,2 µl buffer 4 (NEB) and 0.5 µl FokI
(wildtype Fok from NEB). The
digest was incubated for 30 minutes at 37°C.
Protein - Fluorescein - Interaction
The fluorescence was measured with a NanoDrop 3300 Fluorospectrometer. The excitation maximum of the blue LED is at 470 nm. For each measurement a full emission spectrum from 510 nm to 800 nm was recorded.
Fixed protein concentration in the assay: 40 nM His-FluA-SplitLinker-Fok_i
Variable oligo concentrations in the assay: 3,3 µM; 0,33 µM and 0,033 µM monoligo A
 |
| Initial fluorescence measurement with the NanoDrop 3300 |
Cutting with the Fok_a /Fok_i construct
The first approach was to use a cytosolic solution containing the Fok_a and Fok_i proteins to cut a Cy3-tagged 80 bp oligonucleotide. Therefore co-transformed XL1Blue cells with both constructs (for details: in vivo assay) were incubated till they reached an OD600 of 2 and then centrifuged, resuspended and sonicated. The 80 bp oligo was hybridised with the monoligo A and monoligo B and afterwards incubated for one hour either directly with the sonicated cell suspension or with a centrifuged cell solution.
 |
|
 |
Methods
Hybridize Cy3-tagged nucleotide with monoligo A and B
| Sample 1 | Sample 2 |
| 4 µl 100 mM Tris-HCl pH 8 | 4 µl 100 mM Tris-HCl pH 8 |
| 8 µl 5 mM MgCl2 | 8 µl 5 mM MgCl2 |
| 5 µl Cy3-80mer nucleotide (c = 2500 ng/µl, 100 µM) | 5 µl Cy3-80mer nucleotide (c = 2500 ng/µl, 100 µM) |
| 8 µl fluo-mono-oligo-dig (100 µM) | 6 µl diAB1_fluo-oligo (100 µM) and 6 µl diB1_dig-oligo (100 µM) |
| 15 µl water | 11 µl water |
Thermocycler protocol
| 1. 96°C -> 7 min. |
| 2. 96°C -> 1 min.//-1°C R=0.3°C/sec |
| 3. goto 2 repeat 70 |
| 4. hold 4°C |
Cutting assay
1. Overnight culture of double transformed XL1 Blue cells in DYT ampicilin/chloramphenicol at 24°C
2. Next day inoculated 15 ml DYT ampicilin/chloramphenicol with 100 µl overnight culture
3. Shook at 24°C until OD600 = 1
4. Induced protein expression with 0.6 mM IPTG
5. Shook at 24°C for 1 hour
6. Harvested cells by centrifugation at 5000xg for 15 min. at 4°C
7. Resuspended pellet in 2 ml P1 (50 mM Tris, 1 M NaCl, pH 7.5, protease inhibitor cocktail (PIC) 43 mg/20 ml culture, RnaseI 10 µg/µl
8. Sonicated 5 min. on ice
9. 100 µl aliquot for crude cell lysate cutting assay
10. Centrifuged remaining lysate at 4°C, 16000xg and 10 min. for cleared cell lysate cutting assay
11. Mixed 15 µl of crude or cleared cell lysate with 5 µl of hybridized nucleotides and incubated for 1.5 hours at 37°C
12. Melt cut DNA strands by incubation at 96°C for 4 min.
13. Added loading dye and load onto an 3% agarose gel
