Team:Stanford/ModelingPage

From 2009.igem.org

Revision as of 05:30, 20 October 2009 by Chrisvanlang (Talk | contribs)

Our modeling team consisted of Leon Lin and Mary Yang.

Leon.jpg
Mary.jpg




Contents

Goal

  • To model and optimize the kinetics of these devices.
  • Population dynamics: analyze the conditions to switch between Th17 and Tregs.
  • To predict the results of experiments which we could not perform in the lab
  • ModelingPlan.jpg

Anti-Inflammatory Device

The IPP-->B-carotene-->RA Model

Fig 2.1 A quick sketch of the IPP-->RA process

<center>Fig 2.1 A quick sketch of the IPP-->RA process</center>



Fig 2.2 The B-carotene production pathway [1]

The process above can be devided into two procedures:

  • IPP*8-->B-carotene
  • B-carotene(+Blh)-->Retinal(+RalDH)-->Retinoic Acid


Modeling on the production of B-carotene


The process of IPP producing B-carotene is quite complex, as shown in the Fig 2.2.
In this process, we basically care about two main issues:

  1. Yield output of B-carotene ([B-carotene]/[All Caronoids]).
  2. Velocity of the whole process

Yield output of B-carotene

We found the B-carotene distribution in yeast in [1]. Below is an important form as to the issue.

B-caro distribution.jpg

<center>Form 2.1 B-carotene distribution [1]</center>
Basically, using the cluster of "YB/I/E I", in the final product of caronoids, we get 68% of B-carotene, highest percentage in the paper. (Also 29% Phytoene, and 3% Neurosporene.) "YB/I/E tHMG1 I", producing 52% of B-carotene, might be another choice.

Production rate of B-carotene

As this is a really long process....Basically, the velocity is mainly dependent on the most time-consuming reaction in the whole chain. Thus, Leon and I looked for the kcat values of different enzymes in the procedure, as shown in the cart below:

B-caro para.jpg

<center>Form 2.2 Paremeters in the IPP-->B-carotene model. (Source: mostly from Brenda)</center>

Apparently, cyclization of Lycopene is the slowest reaction, as the concentration of enzymes are approximately in the same level.

Velocity of B-caro production.jpg

Modeling on the B-carotene-->RA process

The production of RA is mainly based on a chain of two catalyzed reactions, as shown in the graph below:

B-caro RA.jpg

<center>Fig 2.3 The production of RA</center> Neither Retinal nor RA has any other degrading process in E.coli. Degrading rate of B-carotene is 9.769e-9 s^-1. Other paremeters we use in this model are shown in the form below:

RA graph.jpg
RA parameter.jpg

<center>Form 2.3 Parameters used in the B-carotene-->RA model</center>

Simulation and Analysis

  • Equations for the IPP-->RA process:

IPP RA equation.jpg

References

[1] High-Level Production of Beta-Carotene in Saccharomyces cerevisiae by Successive Transformation with Carotenogenic Genes from Xanthophyllomyces dendrorhous. APPLIED AND ENVIRONMENTAL MICROBIOLOGY, July 2007, p. 4342–4350

The NO->SoxS-SoxR Model

Anti-Immunosuppresion Device

Models of the Tryptophan System

Wild Type Model Ignoring Cooperativity

Equationsi.jpg
Parametersi.jpg

Base on the fitting to Fig 1 from Reference [2], we came to the result kT=1.62e4 molecules/cell. While the kT measured by Schmitt et al. (1995) is 1.97e4 molecules/cell. The figure below shows the result of our fitting, and the comparison to standard kT value.

Graph1i.jpg

Thus, it is reasonable to calculate k_T values for trp with mutant repressor, 5MT with wildtype repressor, and MT with mutant repressor.

Graph2i.jpg
Graph3i.jpg
Graph4i.jpg

Wild Type Model Including Cooperativity

Graph1w.jpg
Graph2w.jpg
Parametersw.jpg
Equationsw.jpg

</center>

File:Project Overview.jpg