Team:Chiba/Project

From 2009.igem.org

(Difference between revisions)
Line 21: Line 21:
<table width="100%" border="1" cellpadding="1" cellspacing="0" align="center" bordercolor="#800000" align="center">
<table width="100%" border="1" cellpadding="1" cellspacing="0" align="center" bordercolor="#800000" align="center">
<tr><td>
<tr><td>
-
'''Constructing A Delay Switch'''
+
'''[[Team:Chiba/Project/Delay_Switch|Constructing A Delay Switch]]'''
-
</td></tr><tr><td>
+
-
*[[Team:Chiba/Project/Delay_Switch|Overall]]
+
</td></tr><tr><td>
</td></tr><tr><td>
*[[Team:Chiba/Project/Delay_Switch#Experiments|Experiments]]
*[[Team:Chiba/Project/Delay_Switch#Experiments|Experiments]]
Line 33: Line 31:
<table width="100%" border="1" cellpadding="1" cellspacing="0" align="center" bordercolor="#800000" align="center">
<table width="100%" border="1" cellpadding="1" cellspacing="0" align="center" bordercolor="#800000" align="center">
<tr><td>
<tr><td>
-
'''Parallel Activation'''
+
'''[[Team:Chiba/Project/Parallel|Parallel Activation]]'''
-
</td></tr><tr><td>
+
-
*[[Team:Chiba/Project/Parallel|Overall]]
+
</td></tr><tr><td>
</td></tr><tr><td>
*[[Team:Chiba/Modeling|Modeling]]
*[[Team:Chiba/Modeling|Modeling]]
Line 47: Line 43:
<table width="100%" border="1" cellpadding="1" cellspacing="0" align="center" bordercolor="#800000" align="center">
<table width="100%" border="1" cellpadding="1" cellspacing="0" align="center" bordercolor="#800000" align="center">
<tr><td>
<tr><td>
-
'''Series Activation'''
+
'''[[Team:Chiba/Project/Series|Series Activation]]'''
-
</td></tr><tr><td>
+
-
*[[Team:Chiba/Project/Series|Overall]]
+
</td></tr><tr><td>
</td></tr><tr><td>
*[[Team:Chiba/Project/Las Communication Check|Las Check]]
*[[Team:Chiba/Project/Las Communication Check|Las Check]]
Line 73: Line 67:
|}
|}
__NOTOC__
__NOTOC__
-
 
== '''Introduction''' ==
== '''Introduction''' ==

Revision as of 07:25, 4 September 2009

Home

The Project


Constructing A Delay Switch


Parallel Activation


Series Activation


Introduction

Project Design

Signaling System

In this project, we use acylated homoserine lactones (AHLs), signaling molecules used for [http://en.wikipedia.org/wiki/Quorum_sensing quorum sensing] in gram negative bacteria. Senders express LuxI or similar enzymes, which catalyze the production of AHLs, under the control of a constitutive (Tet) promoter. Each cell thus generates AHL more or less at a constant rate. AHL can freely permeate cell membranes and are detected by neighboring cells. Receivers constitutively express LuxR proteins (or a similar ortholog), the protein that detects AHL concentrations. When AHLs bind LuxR proteins, the AHL-LuxR complex activates the Lux promoter. The threshold [AHL] at which switching occurs is determined by the affinity of AHL for the particulr LuxR ortholog. (more about quorum sensing)


Constructing A Delay Switch, Multiple Ways

2008のことを述べ、Mutantの実験をやってない(今年はやる)とせつめい。

In principle, there are three ways to delay the activation of chemical communications;

  1. Silencing the Speakers: Rate of signal accumulation down-regulated, for instance, by slowing down the signal generators.
  2. Desensitize Receivers: Switching threshold elevated, for instance, by using insensitive receiver/ reporter systems.
  3. Partial Blocking: Decreasing the by chewing the signal up.

Constructing A Flow of Activation

1, Parallel Activation

2, Series Activation

Conclusions