Team:Freiburg bioware/Project/invitro

From 2009.igem.org

Revision as of 22:55, 21 October 2009 by Gerrit (Talk | contribs)

FREiGEM


Introduction

After the cloning, expression and the purification of the Fok constructs we conducted several assays to analyse the activity of the enzyme. To establish the assay and as a reference for activity we used wildtype FokI. Binding of the modified nucleotides and enzymatic activity were tested with the Fok_i / Fok_a construct.


Cutting with FokI wildtype

First the ability of FokI wildtype to cut ssDNA hybridized with a short oligonucleotide had to be confirmed. M13 ssDNA was isolated which contains four FokI cutting sites. For two of them complementary oligonucleotides were ordered with a length of 40 bases (Link zur Oligoseite) as a oligo with this length should form a helix with the M13 DNA. The M13 ssDNA was hybridized with the oligonucleotides and then incubated with FokI for 30 minutes. We ran a 1% agarose gel and the first gels showed a strong degredation of the ssDNA with no distinct fragment visible on the gel. But after reducing the amount of FokI and the time of incubation a clear fragment pattern showed up. 

Figure 1: Agarose gel of FokI cutting M13 ssDNA and dsDNA

M: GeneRuler DNA Ladder Mix (Fermentas, 6 µl);
1: Untreated M13 ssDNA (300 ng);
2: Digest of M13 ssDNA with FokI and with the nucleotide Fok control 1;
3: Digest of M13 ssDNA with FokI and with the nucleotide Fok control 2;
4: Digest of M13 ssDNA with FokI and with the nucleotide Fok control 3;
5: Digest of M13 ssDNA with FokI and with the nucleotides Fok control 2 and 3;
6: Digest of M13 ssDNA with FokI and with the nucleotides Fok control 2 and 3, heat inactivation at 95°C 10 min;
7: Digest of M13 ssDNA with FokI and with the nucleotides Fok control 1 and 2;
8: Digest of M13 ssDNA without FokI and with the nucleotides Fok control 1 and 2;
9: Digest of M13 ssDNA with FokI and with the nucleotides Fok control 1 and 3;
10: Digest of M13 ssDNA with FokI and with the nucleotides Fok control 2 and 3, kept on 37°C after the hybridization;
11: Digest of M13 dsDNA with FokI.

The M13 DNA has a size of 7259 bp. The digest of dsDNA with FokI wildtype would lead to the following fragment pattern: 900 bp, 3560 bp, 2780 bp, 200 bp. This pattern was visible at the gel in lane 11. Cutting with the nucleotides Fok control 2 and 3 should create two fragments with sizes of 6100 bp and 1100 bp. The gel picture shows two fragments at the right size in the lanes 5 and 6 and some uncut vector in lane 6. Incubation with Fok control 1 and 2 should cut out a 200 bp fragment which couldn't be seen on the gel in lane 7. Probably the DNA concentration was to low to detect this small insert. The digest with Fok control 1 and 3 in lane 9 didn't provide the fragments of 906 bp and 7100 bp. Maybe the Fok control 1 nucleotide didn't work right, as both digests with this nucleotide failed. The negative control in lane 8 didn't show any shorter fragments. The digest in lane 10 didn't work because we forgot the DNA.

Methods

Hybridize M13 ssDNA with Fok control oligos 2 and 3

Volume Reagent
10 µl M13 ssDNA (c = 127 ng/µl, 17.08.09, sample #5.2)
5 µl MgCl2 (5 mM)
5 µl Tris-HCl pH 8 (100 mM)
2 µl Fok control 2 (10 ng/µl; 1 µM)
2 µl Fok control 3 (10 ng/µl; 1 µM)
30 µl

The hybridization was also done with just Fok control 2 and with no oligos at all.
Incubation with the thermocycler and the program ORIGAMI0 (heat to 95°C and cool down slowly to 37°C over 1 hour).

10 µl of the hybridized DNA were used for a cutting experiment with 1,2 µl buffer 4 (NEB) and 0.5 µl FokI (wildtype Fok from NEB). The digest was incubated for 30 minutes at 37°C.


Protein - Fluorescein - Interaction

We also tested whether the construct binds specifically to the tagged oligonucleotides. To analyse this, a initial fluorescence quenching experiment was conducted. The fluorescein which is bound to the nucleotide is excited at about 500 nm and emits at about 520 nm. When the protein binds, the fluorescence is quenched.
The fluorescence was measured with a NanoDrop 3300 Fluorospectrometer. The excitation maximum of the blue LED is at 470 nm. For each measurement a full emission spectrum from 510 nm to 800 nm was recorded.
Fixed protein concentration in the assay: 40 nM His-FluA-SplitLinker-Fok_i
Variable oligo concentrations in the assay: 3,3 µM; 0,33 µM and 0,033 µM monoligo A

Initial fluorescence measurement with the NanoDrop 3300

Cutting with the Fok_a /Fok_i construct

The first approach was to use a cytosolic solution containing the Fok_a and Fok_i proteins to cut a Cy3-tagged 80 bp oligonucleotide. Therefore co-transformed XL1Blue cells with both constructs (for details: in vivo assay) were incubated till they reached an OD600 of 2 and then centrifuged, resuspended and sonicated. The 80 bp oligo was hybridised with the monoligo A and monoligo B and afterwards incubated for one hour either directly with the sonicated cell suspension or with a centrifuged cell solution. 


Methods

Hybridize Cy3-tagged nucleotide with monoligo A and B

Sample 1 Sample 2
4 µl 100 mM Tris-HCl pH 8 4 µl 100 mM Tris-HCl pH 8
8 µl 5 mM MgCl2 8 µl 5 mM MgCl2
5 µl Cy3-80mer nucleotide (c = 2500 ng/µl, 100 µM) 5 µl Cy3-80mer nucleotide (c = 2500 ng/µl, 100 µM)
8 µl fluo-mono-oligo-dig (100 µM) 6 µl diAB1_fluo-oligo (100 µM) and 6 µl diB1_dig-oligo (100 µM)
15 µl water 11 µl water

Thermocycler protocol

1. 96°C -> 7 min.
2. 96°C -> 1 min.//-1°C R=0.3°C/sec
3. goto 2 repeat 70
4. hold 4°C

Cutting assay
1. overnight culture of double transformed XL1 blue cells in DYT Amp/Chlor @24 °C
2. Next day inoculated 15 ml DYT ampicilin/chloramphenicol with 100 µl overnight culture
3. Shake at 24°C until OD600 = 1
4. Induced protein expression with 0.6 mM IPTG
5. Shake at 24°C for 1 hour
6. Harvested cells by centrifugation at 5000xg for 15 min. at 4°C
7. Resuspended pellet in 2 ml P1
a. P1: a. 50 mM Tris, 1M NaCl, pH 7,5, protease inhibitor coctail PIC 43mg/20ml culture, RnaseI 10µg/µl --> 4µl
8. Sonicated 5 min. on ice
9. 100 µl aliquot for crude cell lysate cutting assay
10. Centrifuged remaining lysate at 4°C, 16000xg and 10 min. for cleared cell lysate cutting assay
11. Cutting assay:
a. mix 15 µl of crude cell lysate with 5µl of hybridized oligos
1. 5 µl hybridized oligonucleotides
2. 12,8 µl crude cell lysate
3. 2 µl 10x Buffer Fok (200 mM Tris-acetate, 500 mM potassium acetate, 100 mM Magnesium Acetate, 10 mM Dithiothreitol, pH 7.9 @ 25°C)
4. 0,2 µl 100x BSA

b. PCR program for incubation:
1. 37 °C 1h 45 min --> DNA is cut
2. 95 °C 4 min --> melt cut strands
3. 89 °C hold --> add 1 µl formamide & 3µl gel loading dye
4. load onto 3 % agarose gel

12. Melt cut DNA strands by incubation at 96°C for 4 min.
13. Added loading dye and load onto an 3% agarose gel

Detection of the Cy3 To excite the Cy3-tagged nucleotides a laser with a wavelength of 353 nm was used. To cut of the excitation wavelength in the pictures a cutoff filter of 580nm was used.