Team:KULeuven/Modeling/Key Antikey

From 2009.igem.org

(Difference between revisions)
Line 19: Line 19:
In the figures that follow time is measured in seconds and quantities in molecules.
In the figures that follow time is measured in seconds and quantities in molecules.
-
In the figure below the blue light input is represented in blue, the vanillin input is green,
+
In the figure below the blue light input is represented in blue, the vanillin input in green and
-
the amount of unlocked key is represented in red.
+
the amount of unlocked key in red.
[[image:key_antikey.png|700px|thumb|center|Simulation of the key antikey system, the bigger the amounts to subtract, the less well the system behaves]]
[[image:key_antikey.png|700px|thumb|center|Simulation of the key antikey system, the bigger the amounts to subtract, the less well the system behaves]]

Revision as of 11:55, 1 September 2009

Contents

Key Lock Antikey

Overview

The Key and Antikey system performs a subtraction of the blue light signal and the vanillin receptor signal. The result controls the vanillin production. The biology behind the subtraction involves the annealing of complementary RNA strands, the Key and the Antikey. This reaction is favoured over the reaction between the Key and the Lock leading to vanillin synthesis. In this way we try to perform the subtraction before inducing production of vanillin.

This biological equivalent of a subtraction can only yield a positive number, so one can only subtract a small from a big amount. Because we can only actively produce vanillin, we have to subtract the measured quantity of vanillin, the amount of anti-key produced by the vanillin receptor from the wanted quantity of vanillin, the amount of key produced by the blue light sensor.

Models

Comparator.png

Simulation

Simulations were conducted to investigate the input output behaviour of the key lock system. In the figures that follow time is measured in seconds and quantities in molecules.

In the figure below the blue light input is represented in blue, the vanillin input in green and the amount of unlocked key in red.

Simulation of the key antikey system, the bigger the amounts to subtract, the less well the system behaves

Because of the nonlinear relationship between input and (anti)key (Michaelis-Menten), the steady state level of key depends on the level of both blue light sensor and vanillin sensor input and not just the difference between the two.

Michaelis-Menten kinetics, when the amount of substrate is small, the rate is proportional to the amount of substrate, the linear region. When the amount of substrate is large, the rate is saturated at Vmax

The most important conclusion is that for good functioning of the differentiator the transcription of both the key and the antikey are operated in the linear region (See figure Michaelis-Menten). It's therefore important that the inputs of this system remain of the same magnitude of the Km of the production of the (anti)key.

Also the half-life of the key and antikey have to be as short as possible, otherwise we subtract the integrated amounts of the signals and not the signals themselves. This should not oppose any problem since the half-life of non translational mRNA strands is just 5 minutes, way faster than the system requires. This reasoning remains valid for all species in the cell, the speed of the cell is limited by the slowest degrading species.