Team:Imperial College London/Drylab/Enzyme/Simulations

Simulation 1: The Generic Graph

This simulation shows the standard enzyme kinetics graph. Concentrations of product, enzyme, substrate, and enzyme-substrate complex over time are shown. Comparisons between the standard enzyme kinetic graph with and without Michaelis-Menten kinetics are made.

In this simulation, all parameters are arbitrary. K1 = 100000, K2 = 1000 and K3 = 0.1. This makes K_M = 0.01. Furthermore, [E₀] = 0.01 and [S₀] = 0.1. The values of K1, K2 and K3 are proportional to their kinetic values [1], while the values of E₀ and S₀ are chosen to ensure a clear graph.

The above simulation shows that the Enzyme-Substrate complex is at a steady state.

There is a decrease in substrate concentration, accompanied by a rise in product concentration. As all the substrate is used up, there will be no more products formed. There is, however, a time delay before significant product formation starts. This time delay occurs as the enzymatic conversion of substrate to product takes some time.

After this time delay, the concentration of ES complex will gradually drop to 0, while the concentration of enzyme will correspondingly return to initial values.

In our case where the enzyme concentration is much smaller than the Km value, there is not much difference in the rate of formation of product when we compare the graphs obtained with the Michaelis-Menten assumption, and the graphs obtained when not making this assumption. This shows that our assumptions of Michaelis-Menten kinetics is valid.

Keeping the parameters the same as above, we perform a simulation of the first few moments of the enzymatic reaction. We can observe the transition state of the standard reaction that we would have missed otherwise. Here, the enzyme concentration will decrease to zero due to the formation of enzyme-substrate complex, and there is a corresponding decrease in substrate concentration by an equal amount. There is no rise in product concentration within this short initial period, as the enzymatic conversion of substrate to product takes some time.

Simulation 2: Varying [S₀]

Here, the values of K1, K2 and K3 are unchanged. [E₀] = 0.01, while [S₀] varies from 0.01 (low in relation to K_M and [E₀]) to 10 (high in relation to K_M and [E₀]).

In this simulation, we have increasing [S₀], while keeping [E₀] constant. The slope of the graph of product vs time gives us rate of production of product. For lower values of [S₀], the rate of production of the product is directly proportional to the amount of [S₀]. However, for higher values of [S₀], rate of production of product saturates at a maximum rate. Increasing [S₀] will no longer have any effects.

When [S₀] is very large, we will get a straight line on the graph of [ES] vs time or . This is when the rate of formation of product purely depends on [E₀] , and that [E₀] is the limiting factor. In this case, we can say that the Michaelis-Menten assumption holds, and therefore,