Please delete as completed.
Autoinduction feedback from todays session.

1) Mention the purpose of AI - No timer because...
2) Don't link to the temporal control page here.
3) Have a rationale section.
4) Add what teams can reuse from this module.
5) Have a conclusion of the page at the end - couple of lines.

Module Integration - Autoinduction

Module 2: Encapsulation

Overview

The autoinduction process switches on Module 2 following the accumulation of a predetermined concentration of polypeptide. The term 'autoinduction' was chosen as the flipping of this switch is triggered by the chemical composition of the media in which our chassis is grown. Thus the 'on signal' orginates from inside the system: hence 'autoinduction'.

Rationale

Before embarking on the creation of an autoinduction switch we reviewed a number of possible alternatives. A genetically encoded timer was initially considered however these present a considerable number of problems:

| The length of our delay can be tuned by altering the composition of our media |}

1) Existing genetic timers are unable to provide a long enough delay.

2) They are liable to fall out of phase.

3) They require multiple genes.

In contrast, using autoinduction media means that the length of our delay can be tuned by altering the composition of our media. In addition, a greater proportion of our bacterial population will react in synchrony to the input signal and thus commence Module 2 at the same time. Lastly, our autoinduction switch only requires a single promoter!

Module 2 Timeline

Initiation

Module 2 is triggered by a rise in levels of cyclic Adenosine Mono Phosphate (cAMP). This is because cAMP facilitates the dimerisation of the transcription factor CRP which induces transcription downstream of the PcstA promoter. The rise in cAMP is correlated with a fall in levels of the primary carbon source (glucose). Thus, by controlling the initial amount of glucose present in the system, we achieve a timer function for the start of Module 2.

Module 2: Initiation

Results

The first of our diauxic growth models is a cybernetic model developed by Kompala et al [1]. This model shows that glucose (S1) is used up before the secondary carbon source (S2). During this phase, the population (X) is in exponential grow until glucose (S1) runs out. This is followed by a stationary growth phase, and finally the population enters a second exponential growth phase as they start uptaking the secondary carbon source (S2). Another model was developed by Keasling [2] that takes into account the dynamics of the lactose operon. //Include a nice diauxic growth curve from the lab

  About the models and simulations!