Team:Aberdeen Scotland/parameters/invest 1

From 2009.igem.org

Revision as of 13:49, 10 August 2009 by Takemusu (Talk | contribs)

University of Aberdeen iGEM 2009

Contents

Dissociation Constants

Introduction

Our model uses hill kinetics; we have three repression hill functions of the form:

Dissociation Constants Eq 1.gif

It has one activation hill function of the form:

Dissociation Constants Eq 2.gif

And one repression / induction hill function of the form

Dissociation Constants Eq 3.gif

Where β is the maximal transcription rate, [X] is the concentration of protein X and Kd is the dissociation constant for molecule X to the operator in question. Similarly, [S] is the concentration of the inducer - S - and Ks is the dissociation constant for the inducer to the repressor, X. Kd is defined as follows:

Dissociation Constants Eq 4.gif

Where koff and kon are the on and off rates in the equation

Dissociation Constants Eq 5.gif

Kd has a more biologically meaningful definition however, it is the concentration of X at which the operator will be repressed 50% of the time.

Discontinuity

The units of Kd are usually given in M, the molarity, or moles-per-litre. Our model works with the exact number of molecules so we may convert our Kd values into molecules-per-cell. This is achieved as follows:

Dissociation Constants Eq 6.gif

Where the volume of the cytoplasm of the cell is 6.7×10-16 litres

This conversion constant of Avogadro’s number multiplied by the cytoplasm volume is ~ 402000000 (402 million).

The problem with this is that most dissociation constants found in the literature equate to a value of molecules per cell that is less than 1. Clearly in a cell with 10 plasmids and therefore 10 operators 1 molecule could not repress all of them!

Below is a table of conflicting information we found. This is an extract from the ETHZ Wiki [6] with the new column of the value in molecule- per-cell added.


Parameter Value Molecules per cell Description
KLacI 0.1 - 1 [pM] OR 800 [nM] 0.00004-0.0004 molecules OR 322 molecules LacI repressor dissociation constant
KIPTG 1.3 [µM] 522 molecules IPTG-LacI repressor dissociation constant
KtetR 179 [pM] 0.07 molecules TetR repressor dissociation constant
KcI 8 [pM] OR 50 [nM] 0.003 molecules OR 20 molecules cI repressor dissociation constant
KHSL 0.09 - 1 [µM] 402 molecules HSL-LuxR activator dissociation constant

And here are the other parameters we found in the literature

Parameter Value Molecules per cell Description Reference
KLacI ~1*10 -12 M OR ~1.8*10-12 M 0.0004 molecules OR 0.00072 molecules Dissociation constant for LacI to LacO DNA site [1][2]
KIPTG 1*10-6 M 402 molecules Dissociation constant for IPTG to LacI [3]
KtetR (5.6 ± 2) × 10-9 M OR 1.53*10-8 M 2.25 molecules OR 6.1506 molecules Dissociation constant for TetR to TetO [4][5]
KcI 50 * 10-9 M 20 molecules Dissocitation constant for cI to DNA site [6]

Discussion

Upon further investigation we have concluded that the majority of Kd values found in papers were unrealistically low for the following reasons:

1. Most Kd values are measured in-vitro, which yields a low measurement since the conditions of the reaction - most notably the salt concentration and pressure - are completely different than in an E.coli cell. The salt concentration affects the reaction significantly since it lowers the electrostatic affinity of the protein to the operon. We know from Thermodynamics that pressure and temperature will change reaction kinetics and hence the in vitro experiments will have different reaction rates and hence different Kd values than would be found in the cell.

2. We have found measurements of Kd values which have been done in conditions which try to replicate in vivo conditions. These Kd values are better, but also infeasibly low, since they do not take into account non-specific DNA binding and cell pressure.

3. In our model, we describe concentrations in terms of molecules-per-cell, instead of moles-per-litre. Upon converting the Kd values from moles-per-lire to molecules-per-cell we found that a great deal the Kd values we found were less than 1 molecule per cell. This implies that less than one protein (LacI, TetR etc.) is required to half the overall production. This is physically irrepresentative for a number of reasons, including the fact that the probability that one protein molecule will collide with a single operon in the cell at the correct angle is close to zero.

We consulted with Prof. Peter McGlynn of the Institute of Medical Sciences in Aberdeen, who agreed with our analysis of the Kd values and introduced the idea of non-specific DNA binding. He showed us a PhD thesis from one of his students, Dr. Bryony Payne, from 2006. In this thesis a far more direct and accurate measurement of the LacO repression was made. It stated that 340 tetramers of LacI were required to fully repress the LacO operon. From this value, we estimated the Kd value for the LacO operon to be 700 molecules-per-cell.

Our new estimations for Kd

Starting our estimation from Dr. Payne's 2006 paper; we are given that 340 LacI tetramers completely repress a promoter. Hence roughly 120 tetramers will give half repression. Assuming the tetramers are stable this gives a value of KLacI - Kd for LacI to LacO - of 4×170 or KLacI ~ 700.

For the LacI-IPTG complex formation, we estimated KIPTG ~1200 using [7] and our value of KLacI above. TetR to TetO seems to have a lower affinity to each other than LacI to LacO. However, the in-vitro values suggest that TetR still binds with a strong affinity to TetR. Thus the KTetR value was roughly estimated to be up to 10 times KLacI. The in-vitro values for cI to its operon seem to suggest that the in-vivo KcI value is of the same order of magnitude, but possibily smaller, than KTetR.

Now we have:

KLacI = 700 molecules per cell

KcI = 7000 molecules per cell

KTetR = 7000 molecules per cell

References

[1] Mitchel Lewis (2005) The Lac repressor. C. R. Biologies 328 (2005) 521–548

[2] Falcon C.M and Matthews K.S. (2000) Operator DNA sequence Variation Enhances High Affinity Binding by Hinge Helix Mutants of Lactose Repressor Protein. Biochemistry. 39, 11074-11084

[3] Uri Alon, An introduction to systems Biology, p244

[4] Nucleic Acids Res. 2004; 32(2): 842–847. Two mutations in the tetracycline repressor change the inducer anhydrotetracycline to a corepressor Annette Kamionka, Joanna Bogdanska-Urbaniak, Oliver Scholz, and Wolfgang Hillen*

[5] Volume 272, Number 11, Issue of March 14, 1997 pp. 6936-6942, The Role of the Variable Region in Tet Repressor for Inducibility by Tetracycline, Christian Berens , Dirk Schnappinger and Wolfgang Hillen

[6] http://parts.mit.edu/igem07/index.php?title=ETHZ/Parameters

[7] Detailed map of a cis-regulatory input function – Y. Setty*,†, A. E. Mayo*,†, M. G. Surette‡, and U. Alon*,†,§