Team:USTC/Modeling/Model-2

From 2009.igem.org

Revision as of 03:23, 22 October 2009 by Zxhe (Talk | contribs)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

USTC
Home Team Project Modeling Parts Standard & Protocol Software Tool Human Practice Notebook

Team:USTC/Modeling/Model-2

Contents


pConX2+LuxR+pLux/Tet+GFP

Parts:


Model-2-2.jpg

Simplified Model-2

We employed an ODE model. We defined the input to be AHLout the and the output to be the synthesis rate of mature GFP. In this system,we assumed the concentration of the LuxR was constant.

S-m-2-1.jpg


To simplify the model, the (Recation S2-4), (Recation S2-5) and (Recation S2-6) were considered to be able to get balance in a very short time.


Sm2-1-1-3.jpg


From above equations, we can estimate the change of PoPS respond to the AHLin.


Sm2-2.jpg


For this system, the value of parameter d, 0.00847, could be estimated based on the measurement of the OD. For instance, when the concentration of AHLout was zero, the value of d was 0.00368 per minute. The values of 4.8E-3 per sec for rmG, 1.8E-3 per sec for a and 0.4 per sec for pG were got from the experiment conducted by Barry Canton and Anna Labno in 2004, click [http://partsregistry.org/Part:BBa_F2620:Experience/Endy/Data_analysis here] to the details.

SM2-3.jpg

With the help of USTC_Software, we succeeded to estimate the values of k3, rAHLin, C1, C2, C3 and C4, using the data from our measurements. The simulation results as follows.

k3=0.8; rAHL=0.001; C1=1.5*10^(-10); C2=1*10^(10); C3=8*10^(-7); C4=5.8*10^(11)

Sm2-4.jpg

In above picture, the dots were the measuring poingts in our system and the curves were the corresponding simulations to a particular concentration of AHLout.


Sm2-5.jpg

In above picture, the dots were the measuring poingts in our system and the surface was the corresponding simulation.