Team:Valencia/WetLab/YeastTeam/Protocols

From 2009.igem.org

Revision as of 16:52, 18 October 2009 by Guimar3 (Talk | contribs)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)














Protocol used to make our yeasts produce light


PROTOCOL OF CITOPLASMATIC Ca2+ INCREASEMENT MEASUREMENT IN S. cerevisiae


Modified from the original Denis and Cyert (2002) JCB 156; 29-34.

Material:

  • pEVP11[AEQ] plasmid: apoaequorina expression (Batiza et al.(1996) J.Biol.Chem. 271: 23357-62).
  • Coelenterazine solution: Diluted coelenterazine until 590μM in satured N2 metanol. This compound is extremely photosensible and it's inhibited by O2. Keep at –20ºC.

Note: We bought Coelenterazine, Native (CLZn) 50 μg Ref. C-2230 de SIGMA. We put N2 gas into metanol during 5 minutes, and we added inmediately 200μL to the 50μg of coelenterazine.

  • Luminometer.
  • Luminometer tubes and ELISA plaques.


Procedure:


1. We recieved pEVP11[AEQ] aequorin transformed yeast from Joaquin Arinyo.


2. We let growing up o/n in SD lacking Leu medium to maintain plasmid expression.


3. After incubation, measure OD a 660nm y calculate the necessary volum to obtain in 250μL a final OD of 1,8. Put that volum into an eppendorf tube with a hole in its tap.


4. Centrifugate 1 minute at 13000rpm.


5. Discard the supernatant.


6. Resuspend the pellet into 250μL of fresh medium with coelenterazine 2μM (aprox. 3,5μL of coelenterazinestock solution / μL de medio).


7. Incubate during 5,5 horas at ambient temperature, in agitation and keeping in the darkness.


8. Centrifugate 1 minute at 13000rpm. Discard the supernatant and resuspend in SD lacking Leu fresh medium without coelenterazine (see the proper volum below *).


9. Wait 15 min (yeast luminiscence is increased due to a peak of Ca2+ is induced by the glucose (Nakajimashimada et al. (1991) PNAS 88; 6878-82).


10. Measure basal luminiscence during 15 minutes.


11. Add the correct reactive volum to induce luminiscence.


In the chase of alcaline induction:


8. *Add 170μL of medium.


9. Add 30μL of KOH 100mM.

Other stress types:

NaCl: 30μL NaCl 5M (0,75M final).

CaCl2: 30μL CaCl2 1.33M (200mM final).

KCl: 30μL KCl 100mM.

Note: yeasts should be treated secuentialy and in the same way to obtain reproducible results.