Team:Cambridge/Notebook/Week4

From 2009.igem.org

(Difference between revisions)
(Dry Work)
(Dry Work)
Line 50: Line 50:
===Dry Work===
===Dry Work===
 +
====Promoter response to input concentration====
 +
*The pBAD promoter currently used in the amplification system is sensitive to different concentrations of arabinose, although this effect could be considered limited, so this is probably not the best promoter to use to get a sequence of outputs at different concentrations [].
<!--Do not remove the first and last lines in this page!--><div id="contentbox_bottom"></div></div>
<!--Do not remove the first and last lines in this page!--><div id="contentbox_bottom"></div></div>
-
 
-
====Promoter response to input concentration====
 
-
*The pBAD promoter currently used in the amplification system is sensitive to different concentrations of arabinose, although this effect could be considered limited, so this is probably not the best promoter to use to get a sequence of outputs at different concentrations [].
 

Revision as of 12:00, 3 August 2009


Week 4 - Development

Monday

Wet Work

Melanin

  • Results from weekend plates:

Cambridge SDC12335.JPG

From left to right, top row: 1mM IPTG with 0.075 mg/mL tyrosine, 1mM IPTG and 0.3 mg/mL tyrosine, and then 1mM IPTG and 0.6 mg/mL tyrosine From left to right, bottom row: 0.075 mg/mL tyrosine, 0.3 mg/mL tyrosine, and then 0.6 mg/mL tyrosine.

It appears that the bacteria were much too high a concentration; they formed lawns. As we saw on the first plates, pigment production is reduced at high bacterial concentrations. However, it is encouraging that the darkest plate is the one with the greatest tyrosine concentration and IPTG.

To follow up, the experiment was repeated with 1/100 and 1/1000 dilutions of bacterial culture on the following plates:

100ug/ml Ampicillin, 15 ug/ml CuSO4, 0.3 mg/mL tyrosine

100ug/ml Ampicillin, 15 ug/ml CuSO4, 0.6 mg/mL tyrosine

100ug/ml Ampicillin, 7.5 ug/ml CuSO4, 0.075 mg/mL tyrosine, 0.5mM IPTG

100ug/ml Ampicillin, 15 ug/ml CuSO4, 0.3 mg/mL tyrosine, 1mM IPTG

100ug/ml Ampicillin, 15 ug/ml CuSO4, 0.6 mg/mL tyrosine, 1mM IPTG

  • Unfortunately, the overnight cultures for the plate readers were contaminated, so a single colony was once again incubated overnight in 10 mL of 100ug/ml Ampicillin, 15 ug/ml CuSO4, 0.3 mg/mL tyrosine, 1mM IPTG in preparation for pigment characterisation using the plate reader.

Amplification

  • Chose 5 activator / promoter combinations to continue work with:
  • P2 ogr activator with
  • PO promoter (I1746371)
  • Psid promoter (I746374)
  • phiR73 delta activator with
  • PF promoter (I746390)
  • PO promoter (I746391)
  • Psid promoter (I74394)
  • Of the above, on plates all showed leaky expression of GFP and RFP, suggesting that last weeks transformation was successful.
  • Inoculated 5 replicates of single colonies overnight of each in preparation for colony PCR and miniprep tomorrow.

Dry Work

Promoter response to input concentration

  • The pBAD promoter currently used in the amplification system is sensitive to different concentrations of arabinose, although this effect could be considered limited, so this is probably not the best promoter to use to get a sequence of outputs at different concentrations [].