Team:TUDelft/17 July 2009

From 2009.igem.org

(Difference between revisions)
(Weenink)
 
(8 intermediate revisions not shown)
Line 1: Line 1:
{{Template:TUDelftiGEM2009}}
{{Template:TUDelftiGEM2009}}
 +
 +
{{Template:TUDelftiGEM2009_LabNotebook}}
='''17th July'''=
='''17th July'''=
 +
 +
=='''Sriram and Tim Vos'''==
 +
All the 3 culture tubes GFP(E0040), TetR(C0040) and cl(C0051) didn't have any culture in the tubes. So these 3 biobricks along with the kanamycin containing biobricks (I14018, I12006 and E1010): totally 6 must be re-transformed. I used the thermomixer instead of using the water bath for heat shock of 42 °C. Also while plating I poured antibiotics (Amp and Kan) in right amounts after the plates were solidified since I read antibiotics are thermal sensitive. Then the transformed cells were plated. While doing all these procedures I tutored the same procedure to Calin for his 4 biobricks as well. Once these 6 plates have good colonies I can do plasmid DNA extraction on tuesday and start assembly on same day. So Delay module is delayed in assembly procedure which should have been started today.
 +
 +
Tim Vos prepared 1 litre LB medium and around 72x5 ml [600ml] culture tubes and 400 ml beaker were sent for autoclaving.
=='''Weenink'''==
=='''Weenink'''==
-
9:45 inoculated 30 ml LB amp in 37ºC shaking incubator<br>
+
9:45 inoculated 30 ml LB amp in 37ºC shaking incubator for the following strains<br>
pSB1AK3<br>
pSB1AK3<br>
pSB1AC3<br>
pSB1AC3<br>
Line 15: Line 22:
BBa_K145201: 27.8 ng/µl<br>
BBa_K145201: 27.8 ng/µl<br>
<br>
<br>
-
BBa_K145280 30ml culture induced with 1mM IPTG at 14:40
+
BBa_K145280 30ml culture induced with 1mM IPTG at 14:40 <br>
 +
<br>
 +
At 17:45 I was done with the plasmid purification of the strains inoculated this morning and the GFP-LVA + TetR generator strain inoculated yesterday. The DNA concentrations of the 95µl volumes are listed below: <br>
 +
pSB1AK3: 72,2 ng/µl; 260/280=2,18;260/230=2,22; <br>
 +
pSB1AC3: 79,2 ng/µl; 260/280=2,19;260/230=2,18;<br>
 +
pSB1AT3: 76,4 ng/µl; 260/280=2,14;260/230=2,10;<br>
 +
BBa_K145280: 141,9 ng/µl; 260/280=1,79;260/230=1,67;<br>
 +
Note that the backbone plasmids have a significantly lower concentration than the GFP-LVA generator strain. This is partly because the GFP-LVA strain had a higher cell density (longer incubation). But also the lysate was much clearer than the other strains. This is also reflected in the 260 nm ratios, which are much lower (=better) for the K145280 strain.
 +
The 30 ml cultures were divided into 15 ml fractions and centrifuged. Elution was done with 50 µl and these fractions were then combined to get the (approx.) 95µl end product. This yield will allow approximately 14 assemblies per backbone.
 +
 
 +
=='''Calin'''==
 +
Riboregulator scheme 1 and scheme 2 Matlab scripts finished. Ordered lambda red plasmids, (pKD46, pKD3, pKD4) from [http://cgsc2.biology.yale.edu Yale CGSC]. Helped Sriram with transformations. Used DH5alpha comptetent cells to transform:<br>
 +
BBa_I714031 - OriT-R<br>
 +
BBa_J23100 - strong promoter<br>
 +
BBa_E0840 - GFP generator<br>
 +
BBa_I13522 - pTet GFP<br>
 +
 
{{Template:TUDelftiGEM2009_end}}
{{Template:TUDelftiGEM2009_end}}

Latest revision as of 14:33, 25 July 2009

Lab Notebook

July
MTWTFSS
    1 2 3 4 5
6 7 8 9 10 11 12
13 14 15 16 17 18 19
20 21 22 23 24 25 26
27 28 29 30 31
August
MTWTFSS
          1 2
3 4 5 6 7 8 9
10 11 12 13 14 15 16
17 18 19 20 21 22 23
24 25 26 27 28 29 30
31
September
MTWTFSS
  1 2 3 4 5 6
7 8 9 10 11 12 13
14 15 16 17 18 19 20
21 22 23 24 25 26 27
28 29 30
October
MTWTFSS
      1 2 3 4
5 6 7 8 9 10 11
12 13 14 15 16 17 18
19 20 21 22 23 24 25
26 27 28 29 30 31
 

17th July

Sriram and Tim Vos

All the 3 culture tubes GFP(E0040), TetR(C0040) and cl(C0051) didn't have any culture in the tubes. So these 3 biobricks along with the kanamycin containing biobricks (I14018, I12006 and E1010): totally 6 must be re-transformed. I used the thermomixer instead of using the water bath for heat shock of 42 °C. Also while plating I poured antibiotics (Amp and Kan) in right amounts after the plates were solidified since I read antibiotics are thermal sensitive. Then the transformed cells were plated. While doing all these procedures I tutored the same procedure to Calin for his 4 biobricks as well. Once these 6 plates have good colonies I can do plasmid DNA extraction on tuesday and start assembly on same day. So Delay module is delayed in assembly procedure which should have been started today.

Tim Vos prepared 1 litre LB medium and around 72x5 ml [600ml] culture tubes and 400 ml beaker were sent for autoclaving.

Weenink

9:45 inoculated 30 ml LB amp in 37ºC shaking incubator for the following strains
pSB1AK3
pSB1AC3
pSB1AT3

11:30 purified plasmids
(in conctrary to protocol i accidentally added >350µl lysis buffer, so i also added 450µl neutralisation buffer) Yield of 100 µl elution:
BBa_B0032: 21.2 ng/µl
BBa_K145015: 33.0 ng/µl
BBa_K145201: 27.8 ng/µl

BBa_K145280 30ml culture induced with 1mM IPTG at 14:40

At 17:45 I was done with the plasmid purification of the strains inoculated this morning and the GFP-LVA + TetR generator strain inoculated yesterday. The DNA concentrations of the 95µl volumes are listed below:
pSB1AK3: 72,2 ng/µl; 260/280=2,18;260/230=2,22;
pSB1AC3: 79,2 ng/µl; 260/280=2,19;260/230=2,18;
pSB1AT3: 76,4 ng/µl; 260/280=2,14;260/230=2,10;
BBa_K145280: 141,9 ng/µl; 260/280=1,79;260/230=1,67;
Note that the backbone plasmids have a significantly lower concentration than the GFP-LVA generator strain. This is partly because the GFP-LVA strain had a higher cell density (longer incubation). But also the lysate was much clearer than the other strains. This is also reflected in the 260 nm ratios, which are much lower (=better) for the K145280 strain. The 30 ml cultures were divided into 15 ml fractions and centrifuged. Elution was done with 50 µl and these fractions were then combined to get the (approx.) 95µl end product. This yield will allow approximately 14 assemblies per backbone.

Calin

Riboregulator scheme 1 and scheme 2 Matlab scripts finished. Ordered lambda red plasmids, (pKD46, pKD3, pKD4) from [http://cgsc2.biology.yale.edu Yale CGSC]. Helped Sriram with transformations. Used DH5alpha comptetent cells to transform:
BBa_I714031 - OriT-R
BBa_J23100 - strong promoter
BBa_E0840 - GFP generator
BBa_I13522 - pTet GFP